3D printing adhesive for Polypropylene (PP).
MAGIGOO PP is designed for professional use, to work exclusively with polypropylene filaments. The part should be relatively easy to remove once it cools and the glue residue should also be easily cleaned off if the included procedure is followed.
Polypropylene (PP) is a thermoplastic semi-crystalline polymer exhibiting properties of good impact resistance and ductility. It also has a relatively non-polar molecular structure which makes it chemical resistant and thus ideal for use in food packaging and medical equipment. It is in fact well known in the adhesive industry that it is difficult to adhere polyolefin materials to other types of materials. This combined by the partial crystallinity makes it an especially hard material to print with. Magigoo PP solves this issue and provides additional convenience for use in FDM 3D Printing.
Using this product with other than PP type filaments might cause over adhesion and damage your build surface.
The applicator has an active spring valve, which activates when applicator is pressed against the build plate. Please do not press the bottle as "ketchup bottle" , otherwise the applicator may pop off. Bottle may be slightly squeezed, only when the nib is pressed against the bed and it may be necessary only if bigger flow is required. Bottle must not be squeezed when cap is off any other time as it may result in glue popping out of the bottle.
MAGIGOO PP has been designed and tested to work with different PP filament brands.
In cases of excess adhesion, it is recommended to wet print bed with a small amount of water slowly work it below the part, this should make part removal easier. If your prints are not self releasing after the bed cools, increasing the z offset (nozzle gap) may be required.
MAGIGOO PP is best stored upright, with the cap closed and away from direct sunlight.
Q: How do I apply Magigoo?
A: It is best to apply Magigoo when the printing bed is cool. Before applying, shake the Magigoo pen like you mean it, press down the nib on the printing bed for Magigoo to flow. Spread more or less evenly on the printing area. It is enough to cover your active print area with an even thin layer. DO NOT SQUEEZE the bottle to avoid applicator popping off. Applicator has a valve which is activated once you push on it.
Q: Do I need to apply Magigoo everytime?
A: For good and reliable adhesion we recommend to apply Magigoo every time.
Q: How do I clean my bed after using Magigoo?
A: After your prints have finished and popped off, clean the printing bed by wiping with a damp cloth. Yes, just water is enough.
Q: How long will Magigoo last for?
A: One Magigoo 50ml pen is good for on average 100 prints. There is no firm best before date as it will vary depending on use and storing conditions - Once opened, we recommend to use it in a couple of months.
Q: Will Magigoo work with my existing printing surface?
A: Magigoo was originally formulated with borosilicate glass surfaces in mind however we have also had good success applying Magigoo to surfaces like Buildtak, in these cases Magigoo can work as a release agent for materials which can over-adhere.
3D Printing Solutions was established in 2013 by CEO Michael Tyson to distribute high quality 3D printers and supplies to enthusiasts, businesses, government and educational institutions across Australia and New Zealand.
Australian owned and operated, here at 3D Printing Solutions we are dedicated to ensuring your success by providing high quality solutions and sharing our years of hands on experience and support. One of our key philosophies is to thoroughly test the printer brands and filaments we sell to ensure they meet our key quality standards. Our collaborative and in-depth experience with these brands ensures we can provide detailed comparisons and advice to customers.
Dont know where to start? Or which filament will suit your application?
We have a broad range of support options including Telephone Support